Who the Presence Multisensor If the existing fixture is too large or you would prefer to mount the presence detector on the wall instead of the ceiling, you can alternatively use this KNX-compatible compact wall-mounted presence sensor kit.
This means that an HF presence sensor together with an optional brightness sensor can be discreetly integrated into the standard switch range from Gira and JUNG.
If no brightness sensor is required, you will only see the cover plate from Gira or JUNG.
If you also want to measure the brightness and order the corresponding cover plate from Gira or JUNG here, it automatically comes with a small, 2 mm hole in the place of the brightness sensor. The hole is horizontally centered and is milled in exactly the right place using a CNC machine.
Optionally, a sensor for temperature, humidity, air pressure, and VOC can be used. This is simply plugged onto the circuit board and soldered in place. There are also two resistors on the PCB, marked "280" and "680." If the "BME280" is used as a sensor, the resistor numbered "680" must be removed, and vice versa. If the sensor is ordered with the sensor and everything is soldered, the corresponding resistor is also removed.
A standard flush-mounted box (Ø 68 mm, screw spacing: 60 mm) can also be ordered:
The required installation depth of the presence detector is only approx. 25 mm, so a 40 mm deep box is generally sufficient.
If you have any questions or feedback about the project, please make contact!
Please note:
To install the firmware of all KNX-compatible projects offered here in the shop, this programmer needed.
Delivery as a kit:
All KNX-compatible projects offered in the shop are supplied as kits and without software. Users are free to install their own software or the software available via the OpenKNX "Open Source" directories on GitHub (OAM Room Controller) is available. In the latter case, this can be done with the OpenKNX Toolbox easiest.
