Who the Presence Multisensor If the existing fixture is too large and the additional sensors are not needed, this KNX-compatible compact presence sensor kit for MR16 spot housings can be used as an alternative.
This allows an HF presence sensor together with an optional brightness sensor to be installed discreetly in an MR16 spot housing. A 3D-printed mounting spacer, fastening screws and the CNC-milled, opal acrylic glass panel for covering (⌀ 45.5 mm) can also be ordered at the same time.
The installation has been tested with a range of spot holders, so it can be assumed that the sensor can be installed in most mounts.
If desired, a tested and therefore guaranteed suitable spot holder (installation hole diameter: 68 mm) can also be ordered directly. The required installation depth is only approx. 30 mm.
If you have any questions or feedback about the project, please make contact!
Please note:
To install the firmware of all KNX-compatible projects offered here in the shop, this programmer needed.
Delivery as a kit:
All KNX-compatible projects offered in the shop are supplied as kits and without software. Users are free to install their own software or the software available via the OpenKNX "Open Source" directories on GitHub (OAM Room Controller) is available. In the latter case, this can be done with the OpenKNX Toolbox easiest.
